Gunfighter Mk.III – Base Only
Recommended for VKB customers who wish to use their existing VKB grip with a VKB Gunfighter Mk.III joystick base.
Important shipping note:
This product is sold out and will not be shipped until around April / May 2023. We apologise as we cannot accept any new orders in the meantime. Please subscribe to our newsletter as we will advise our customers when the item is available for ordering again. We apologise for this situation.
Included Gunfighter Mk.III Base
- Gunfighter MK.III Base (Rev.B)
- BlackBox Mk2
- Tabletop base plate
- Combo Cams Kit
- 50 cm (1.6′) interface cable
- 180 cm (6′) USB 2.0 cable
- Set of springs (10, 20A, 30A, 40A)
- Spring installation tool
- Grip fastener
Hardware
- Built to Last
- All-metal gimbal w/ adjustable axis dampers
- Swappable cams and springs
- “Avia” cams with progressive loading (soft and hard centre)
- “Space” cams with linear loading (soft and hard centre)
- Cams made of hardened stainless steel alloy
- Wide stance tabletop base plate
- Blackbox w/ 32-bit ARM MCU active USB 2.0 controller
Features
- Works with all flight simulations
- No drivers required
- Digital Hi-resolution contactless sensors
- Save and load custom profiles
- Software tunable axes
- Upgradeable firmware via USB interface
Compatible Grips
- VKB MCG Modern Combat/Ultimate Grip (3-pin Rev.B)
- VKB SCG Space Combat Grip (3-pin Rev.B)
- VKB KG12 WWII Combat Grip (3-pin Rev.B)
- VKB F-14 Combat Grip (3-pin Rev.B)
NOTE: The clutch dampers may be tightened at the factory to prevent them from loosening during shipping; before you connect your Gunfighter to your PC, you will need to loosen the dampers for both pitch and roll axes to achieve correct return-to-centre axes movements after calibration (refer to the Gunfighter Quick Guide for details).
Warranty
Instructions
Downloads
- Please visit the Downloads section for configuration software, device firmware, as well as software documentation.
